Honda CR-V 1997 Service Manual page 1045

Seats
Rear Seat Removal and Installation (cont'dl
2. Fold the seat cushion forward, and remove the base
frame cover, then remove the bolts and nut.
NOTE: The rear seat without tilt is shown, the rear
seat with tilt is the same manner .
.. : Bolt strew locations
~,1
8x 1.25 mm
22
Nom
12.2 kgf .... ,
161bHI!
.: Nut location. 1
8x 1.25 mm
22 N-m 12.2 kgf .... ,
16 IbHt!
SEAT CUSHION
3. Remove the headrest.
REAR
SEAT
SEAT BELT BUCKLES
(CENTER BELT TONGUE!
4. Carefully remove the rear seat through the door open-
ing.
NOTE: An assistant is helpful when removing the rear
seat.
20-64
5. With tilt: If necessary, remove the striker.
STRIKER
6. Installation is the reverse of the removal procedure.
NOTE: Make sure the rear seat belt buckles and
center belt tongue are routed properly (without tilt).