Sub-Shaft Bearing Replacement - Honda CR-V 1997 Service Manual

Transmission Housing Bearings
Sub-shaft Bearing Replacement
1. Expand the snap ring with snap ring pliers, then
push the bearing out of the transmission housing
using the special tools and a press as shown.
Do not remove the snap ring unless it's necessary
to clean the groove in the housing.
DRIVER
07749 - 0010000
ATTACHMENT.
62x68mm
07746 - 0010500
14-228
PRESS
SNAP RING
ATTACHMENT.
62x68mm
07746 - 0010500
TRANSMISSION
HOUSING
2. Expand the snap ring with snap ring pliers, then
coat the new bearing with ATF and insert it part-
way into the housing using the special tools and a
press as shown. Install the bearing with the groove
facing outside the housing.
3. Release the pliers, then push the bearing down into
the housing until the ring snaps in place around
it.
DRIVER
07749 - 0010000
ATTACHMENT.
62x68mm
07746 - 0010500
GROOVE
4. After installing the bearing. verify the following :
• The snap ring is seated in the bearing and hous-
ing grooves.
• The snap ring does not bind.
• The ring end gap is correct.
ENDGAP:0-1 mm
10 -0.28 inl
SNAP
RING