Honda CR-V 1997 Service Manual page 439

Release Bearing
installation
NOTE: Use only Super High Temp Urea Grease (PIN
08798 - 9002).
1. With the release fork slid between the release bear-
ing pawls, install the release bearing on the main-
shaft while inserting the release fork through the
hole in the clutch housing .
.-
IPIN 08798 - 9002)
~
RELEASE
FORK
BOOT
RELEASE
FORK
SPRING
BEARING
• emm
JIa· _ - " »
• ..r;.;;m.,
RELEASE
FORK
(PIN 08798 - 9002)
1.0-1.6g
(0.00 - 0.06 ozl
2. Align the detent of the release fork with the release
fork bolt. then press the release fork over the
release fork bolt sequarely.
12-12
3. Move the release fork right and left to make sure
that it tits properly against the release bearing, and
that the release bearing slides smoothly.
RELEASE
RELEASE
BEARING
4. Install the release fork boot; make sure the boot
seal s arou nd the release fork and clutch housing.