Honda CR-V 1997 Service Manual page 814

Rear Differential Assembly
Reassembly (cont'd)
7. Install the clutch hub/plates/discs, then align the pro-
jection of the plates with the discs.
~M'30mm
CLUTCH GUIDE
CLUTCH HUB/PLATES/
DISCS
8. Install the clutch guide and the 30 mm shim.
9. Apply liquid gasket to the sealing surface of the
torque control differential case, and note these
items:
• Use liquid gasket (P/N 08718 - 00011.
• Remove any dirt or fluid from the sealing sur-
face.
• If 20 minutes have passed after applying liquid
gasket, reapply it before you assemble the hous-
ings. Allow it to cure at least 30 minutes after
assembly before filling differential with fluid.
......
~--
15-24
TOROUE CONTROL
DIFFERENTIAL
CASE
10. Install the dowel pins and torque control differential
case.
TOROUE CONTROL
6x1.0mm
12 N'm 11.2 kgf·m, 8.7lbf.ftl
DOWELptNS
11. Install the companion flange, O-ring, back-up ring,
disc spring washer, and the locknut.
NOTE: Apply CVT fluid to the O-ring.
Install in this direction .
~/LOCKNUT,
24 mm
6"
/DISCSPRINGWASHER,
2'mm
0 -
BACK-UP RING
o...-O-RING
8
COMPANION FLANGE