Sealing Rings - Honda CR-V 1997 Service Manual

Mainshaft
Inspection {cont'd)
5. If the clearance is out o f standard, remove the
thrust washer and measure its thickness.
THRUST WASHER
6. Select and install a new washer, then recheck the
clearance, and make sure it is within standard.
THRUST WASHER 36.5 x 55 mm
No. Part Number
Thickness
1 90441 - PG4 - 010 4.00 mm (0.157 inl
2
90442 - PG4 - 010 4.05 mm (0.159 inl
3 90443 - PG4 - 010 4.10 mm (0.161 inl
4 90444 - PG4 - 010 4.15 mm (0.163 inl
5 90445 - PG4 - 010 4.20 mm (0.165 inl
6
90446 - PG4 - 010
4.25 mm (0.167 inl
7 90447 - PG4 - 010 4.30 mm (0.169 inl
8 90448 - PG4 - 010 4.35 mm (0.171 inl
9
90449 - PG4 - 010 4.40 mm (0.173 inl
10 90450 - PG 4 - 000 4.45 mm (0.175 inl
14-204
Sealing Rings
Replacement
The sealing rings (35 mm and 29 mm) are synthetic resin
with chamfered ends. Check the condition of the sealing
rings, and replace them only if they are worn , distorted,
or damaged.
NOTE: Apply ATF to all parts during assembly.
1. For a better fit, squeeze the sealing ring together
slightly before installing them ,
SEALING RING
2. Install new sealing rings on the mainshaft.
3. After installing the sealing rings, verify the follow-
ing:
• The sealing rings are fully seated in the groove.
• The sealing rings are not twisted.
• The chamfered ends of the sealing rings are
properly joined.
SEAliNG RING
Install the sealing ring
mating faces as shown .