Input Test - '98 - 00 Models - Honda CR-V 1997 Service Manual

Input Test - '98 - 00 Models
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS
section
(24)
before performing repairs or service.
1. Remove the driver's dashboard lower cover and the knee bolster (see section 20).
2. Disconnect the 15P connector from the integrated control unit.
3. Remove the integrated control unit from the under-dash fuse/relay box.
4. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector and the fuse/relay box socket.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty; replace it.
UNDER-DASH
FUSE/RELAY BOX
15P CONNECTOR---+f.::'
RED/BLU
AS ... -----A14
FUSE/RELAY BOX
SOCKET
BLU/RED
Wire side of
female terminals
LT GRN/RED
(conl'd)
23-71