Honda CR-V 1997 Service Manual page 1157

5. Remove the bolt and holder, and screw and clamp,
then disconnect the field coil connector. Remove
the snap ring A with snap ring pliers, then remove
the field coil. Be careful not to damage the field coil
and compressor.
/ \
i \
I
• I
HOLDER
I
I
I
I
. / GROUND
~~
/
', ~ ,
7 . .tN·m
'. _ . / {O.75 kgf·m,
~
5Ib"'t}
"-._ '
6. Position the rotor pulley squarely over the field coil.
7.
Press the rotor pulley onto the compressor boss
with the special tool. If the rotor pulley does not
press on straight, remove it, and check the rotor
pulley and compressor boss for burrs or damage.
CAUTION: Maximum press load: 39,200 kPa
{400 kgf/cm', 5,690 psi)
Reassemble the compressor clutch in the reverse
order of disassembly. Make note of the following
items.
• Install the field coil with the wire side facing down,
and align the boss on the field coil with the hole in
the compressor.
• Clean the rotor pulley and compressor sliding
surfaces with non-petroleum solvent.
• Install new snap rings A and B.
• Make sure the snap rings are fully seated in the
groove.
• Make sure that the rotor pulley turns smoothly
after it's reassembled.
• Route and clamp the wires properly or they can
be damaged by the rotor pulley.
22-67