Backlash Inspection; Bearing Replacement - Honda CR-V 1997 Service Manual

Backlash Inspection
1. Place the differential assembly on V-blocks.
2. Install the driveshaft and intermediate shaft on the
differential assembly.
3. Check the backlash of both pinion gears.
STANDARD: 0.05 - 0.15 mm (0.002 - 0.006 in)
DIAL INDICATOR
DIFFERENTIAL ASSEMBLY
4. If the backlash is out of standard, replace the differ-
ential carrier.
Bearing Replacement
NOTE: Check bearings for wear and rough movement.
If bearings are OK, removal is not required.
1. Remove the bearings using a bearing puller.
BEARING PULLER
IComn,.,,:;alll ' Y
ava ilable)
2. Install new bearings using the special tool as
shown.
PRESS
DRIVER 40 mm I.D.
07146 - 0030100
14-223