Honda CR-V 1997 Service Manual page 1020

15. Pack adhesive into the cartridge without air pockets
to ensure continuous delivery. Put the cartridge in a
caulking gun, and run a bead of adhesive around
the edge of the quarter glass as shown.
NOTE:
• If the old quarter glass is to be reinstalled, peel
the separator off the butyl tape after applying the
adhesive .
• Apply the adhesive within
30
minutes after apply-
ing the glass primer.
~;;;:.I ~
: ADHESIVE
-+-+-
GLASS
8mm
10.31
in.!
BUTYL
TAPE
BUTYL TAPE
25mm
MOLDING
I i
~a
a
v~v
t
GLASS
2mm
16. Use suction cups to hold the quarter glass over the
opening, align the clips or the alignment marks made
in step 9, and set it down on the adhesive. Lightly
push on the Quarter glass until its edges are fully
seated on the adhesive all the way around.
NOTE: 00 not open or close the doors until the
adhesive is dry.
SUCTION CUPS
BUTYL
TAPE
17. Scrape or wipe the excess adhesive off with a putty
knife or towel.
NOTE: To remove adhesive from a painted surface
or the quarter glass, wipe with a soft shop towel
dampened with alcohol.
18. Let the adhesive dry for at least one hour, then
spray water ove r the quarter glass and check for
leaks. Mark the leaking areas, let the quarter glass
dry, then seal with sealant.
NOTE : Let the vehicle stand for at least four hours
after quarter glass installation. If the vehicle has to
be used within the first four hours, it must be driven
slowly.
19. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following
things for two to three days:
• Slam the doors with all the windows rolled up .
• Twist the body excessively (such as when going
in and out of driveways at an angle or driving
over rough, uneven roads).
20-39