Honda CR-V 1997 Service Manual page 448

12. Disconnect the heated oxygen sensor (H02S) con-
nector, then remove the exhaust pipe
A.
GASKET
Replace .
Replace.
SElF·lOCKING NUT
Replace.
I@
SELF· lOCKING NUT
\ Replace.
GASKET
Replace.
13. Mark reference marks on the joint of the transfer
and the propeller shaft.
REFERENCE MARKS
PROPELLER
8x mm
Replace.
14. Separate the propeller shaft from the transfer
assembly.
15. Remove the cotter pins, and castle nuts, then sepa-
rate the ball joints from the lower arm (see section
181.
DAMPER PINCH BOLT
Replace .
fi~
CASTLE NUT \
DAMPER FORK DAMPER FORK
BOLT
COTTER PIN
Replace.
16. Remove the right damper fork bolt, then separate
right damper fork and damper.
17. Pry the right driveshaft out of the differential, and
pry the left driveshaft out of the intermediate shaft
(see section 18).
18. Pull out the inboard joint, and remove the right and
left driveshaft (see section 18).
19. Tie
plastic bags over the drives haft ends. Coat all
precision finished surfaces with clean engine oil.
PLASTIC
BAG
SET RING
Replace.
(cont'dl
13-9