Differential Carrier Replacement - Honda CR-V 1997 Service Manual

Differential
Differential Carrier Replacement
NOTE: The illustration shows the 4WD automatic trans-
mission differential; the 2WD differential is similar.
1. Remove the snap ring from the differential carrier.
SNAP RING
2. Remove the 5
x
15 mm rolier 14WD) or 5
x
10 mm
roller 12WD) and the speedometer drive gear.
SPEEDOMETER DRIVE GEAR
3. Remove the bolts securing the final driven gear and
the transfer shaft drive gear (4WD). then replace the
differential carrier.
14-224
4. Install the final driven gear on a new differential car-
rier with its chamfered sid e facing the carrier and
the transfer drive gear (4WD).
5. Tighten the bolts to the specified torque.
NOTE: The 2WD different ial bolt has left- hand
threads.
t::
10. 1.0 mm
QQ .
103 N·m 110.5 kgf·m,
hl hl
75.9IbUt)
6. Install the speedometer drive gear with its cham-
fered side facing the carrier. Align the cutout on the
bore of the speedometer drive gear with the 5 x 15
mm roller 14WD) or 5 x 10 mm roller 12WD).
7. Align the hooked end of the snap ring with the
spring pin in the pinion shaft. then install the snap
ring in the differential carrier groove.
SNAP RING
Install in this direction.
PINION SHAFT
SPRING PIN
GRDOVE