Honda CR-V 1997 Service Manual page 678

Pressure Testing
(cant'd)
Line Pre •• ure, 1st Clutch, 1st-hold Clutch Pressure Measurement
1. Start the engine, and shift to
00
or
~
position.
2. Run the engine at 2,000 rpm , then measure line pressure. Higher pressure may be indicated if measurements are
made in shift lever positions other than
[ID
or
~ position.
3. Shift to
[Q;J
('97 - 98) or
rID
('99 - 00) position and hold the engine at 2,000 rpm, then measure 1st clutch pressure.
4. Shift to
[I]
position and hold the engine at 2,000 rpm, then measure 1st-hold clutch pressure.
SHIFT LEVER
PRESSURE
POsmDN
Line
ooor~
1st Clutch
[Q;J
('97 - 9S)
rID
('99 - 00)
lst-ho(d
[I]
Clutch
14-162
LINE PRESSURE
INSPECTION HOLE
LOCK-UP CONTROL
SOLENOID VALVE
AlB ASSEMBLY
t
ST CLUTCH PRESSURE
INSPECTION HOLE
lST-HOLO CLUTCH
PRESSURE INSPECTION
HOLE
FLUID PRESSURE
SYMPTOM PROBABLE CAUSE
Standard Service Limit
No (or low) Torque converter, 830 - 880 kPa 780 kPa
line pressure ATF pump, pres- (S.S - 9.0 kgf/cm', (S.O kgf/cm', 110 psi)
sure regulator, 120 - 130 psi)
torque converter
check valve
No or low 1st 1st Clutch
pressure
No or low 1st- 1st-hold Clutch
hold pressure