Honda CR-V 1997 Service Manual page 679

2nd, 3rd, and 4th Clutch Pressure Measurement
'97 - 98 Models:
1. Stan the engine, and shift to
I1J
position.
2. Run the engine at 2,000 rpm, then measure 2nd
clutch pressure.
3. Shift to
IlliI
position, and hold the engine at 2,000
rpm , then measure 3rd clutch pressure.
4. Shift to {Q!I position, and hold the engine at 2.000
rpm , then measure 4th clutch pressure.
5. Shift to
lID
position, and hold the engine at 2,000
rpm, then measure 4th clutch pressure.
4Tli CLUTCH PRESSURE
INSPECTION HOLE
;
/
1ST CLUTCH
PRESSURE~"
INSPECTION HOLE
'99 - 00 Models:
1. Start the engine, and shift to
[!)
position.
2. Run the engine at 2.000 rpm , then measure 2nd
clutch pressure.
3. Shift to [Q) position, and turn the Over-Drive (010)
OFF by pressing the 010 switch (010 OFF indicator
light comes on).
4. Hold the engine at 2,000 rpm, then measure 3rd
clutch pressure.
5. Turn the Over-Drive ON by pressing the 010 switch
(010 OFF indicator light goes out), and hold the
engine at 2,000 rpm, then measure 4th clutch pres
w
sure.
6. Shift to
lID
position, and hold the engine at 2,000
rpm, then measure 4th clutch pressure.
3RO CLUTCH PRESSURE
INSPECnON HOLE
FLUID PRESSURE
SHIFT LEVER
PRESSURE
POSITION
SYMPTOM PROBABLE CAUSE
Standard Service Limit
2nd Clutch
rn
No o r low 2nd 2nd Clutch 800 - 850 kPa 760 kPa
pressure (8.2 - 8.7 kgf/cm', (7.7 kgf/cm', 110 psi)
120 -124 psi)
3rd Clutch IQij ('97 - 98)
No or low3rd
3rd Clutch
[Q)
with Over-
pressure
Drive is OFF
('99 - 00)
4th Clutch [Q;J ('97 - 98)
No or low 4th 4th Clutch
[Q) ('99 - 00) pressure
[BJ
Servo Valve or 4th
Clutch
14-163