Honda CR-V 1997 Service Manual page 496

20. Remove the parts on the transfer shaft. and remove
the transfer shaft from the transfer housing.
TAPERED ROLLER
BEARING
GEAR
TRJINS;FER SHAFT
TR.AN'SFE R HOUSING
THRUST SHIM, 25
mm
Selective part
CONICAL SPRING
WASHER
Replace.
LOCKNUT
Replace .
Transfer Driven Gear Shaft Starting Torque Inspection
and Adjustment
21 . Secure the transfer housing in a bench vise with
soft jaws.
COMPANION FLANGE HOLDER
07RAB - 002000O
22. Install the special tool on the companion flange ,
then remove the transfer driven gear shaft locknut
and the conical spring washer.
23. Remove the transfer driven gear shaft and the com-
panion flange .
24. Install the new transfer spacer on the transfer dri-
ven gear shaft. then instaH them in the transfer
housing.
TRANSFER DRIVEN
GEAR SHAFT
TRANSFER SPACER
Install in this direction .
Replace.
TRANSFER
25. Install the companion flange, O-ring, back-up ring,
conical spring washer and locknut on the transfer
driven gear shaft.
NOTE:
• Coat the threads of the locknut. O-ring and trans-
fer shaft with MTF before installing the locknut.
• Install the conica l spring washer in the direction
shown.
COMPANION
FLANGE
BACK-UP "' .. ,,---
TR~'NSFER
HOUSING
CONICAL SPRING
Replace.
Replace.
(cont'd)
13-57