Honda CR-V 1997 Service Manual page 579

NOTE: When the OeD II Scan Tool or Honda PGM Tester indicate DTC(s) for the automatic transmission control system,
the scan tool or tester indicates code P0700 simultaneously. Code P0700 means a detection of some automatic transmis-
sion problem in the PGM-FI control system.
If the self-diagnostic
~
or@ indicator light does not blink, perform an inspection according to the table below.
Symptom
Inspection
Ref. page
\Q!J
or
(Q]
indicator light does not come on for two seconds after ignition
14-123
switch is first turned ON (II).
[Q!]
or
[Q]
indicator light is on constantly (not blinking) whenever the
14-125
ignition switch is ON
(II).
Shift lever cannot be moved from
~
position with the brake pedal
Check shift lock system 14-126
pressed.
Ignition key cannot be moved from ACC
(I)
position to LOCK (0) posi-
Check key interlock system 14-129
tion with the shift lever in
~
position.
DID
OFF indicator light does not come on for two seconds after ignition
14-131
switch is first turned ON (II). ('99 - 00 models)
The 0 10 OFF indicator light is on constantly whenever the ignition
14-132
switch is ON
(II) .
('99 - 00 models)
The
DID
OFF indicator light does not come on even though the Over- Check Over-Drive (010)
14-133
Drive (010) switch is pressed in
lID
position. ('99 - 00 models)
switch circuit
NOTE: If a customer describes the symptom for code P1706 (6), it will be necessary to recreate the symptom by test-driv-
ing, then recheck the DTC.
14-63