Linear Solenoid Assembly
Replacement
1.
Remove the mounting bolts and the linear solenoid
assembly.
Clean the mounting surface
and fluid passages.
6x1.0mm
12 N·m (1.2 kgf·m,
8.7 Ibf.fl)
J
LINEAR
SOLENOID
ASSEMBLY
2.
Clean the mounting surface and fluid passage afthe
linear solenoid assembly and transmission housing.
3.
Install a new linear solenoid assembly with a new
gasket. Do not pinch the gasket during installation,
and make sure it is installed properly in the mount-
ing groove of the linear solenoid.
4.
Check the linear solenoid connector for rust, dirt, or
oil, then connect
it
securely.
14-138
Mainshaft/Countershaft
Speed Sensors
Replacement
1.
Remove the 6 mm bolt and the countershaft speed
sensor from the end cover.
6x 1.0 mm
12 N·m 11.2 kgf·m,
8.7 Ibf.fl)
\
COUNTERSHAFT
/
6x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 Ibf.fl)
2.
Remove the 6 mm bolt and the mainshaft speed
sensor from the transmission housing.
3.
Replace the O-ring with a new one before installing
the countershaft speed sensor or the mainshaft speed
sensor.