Honda CR-V 1997 Service Manual page 761

20. Remove the parts on the transfer shaft, and remove
the transfer shaft from the transfer housing.
TAPERED ROLLER
BEARING
TRANSFER
COLLAR
TRANSFER SHAFT
TRANSFER HOUSING
, Tt'RLIST
SHIM.
25
mm
Selective pa
rt
CONICAL SPRING
WASHER
Replace.
Replace.
Transfer Driven Gear Shaft Starting Torque Inspection
and Adjustment
21. Secure the transfer housing in a bench vise with
soft jaws. To prevent damage, always use soft jaws
or equivalent materials between the transfer hous-
ing and the vise.
22. Install the special tool on the companion flange,
then remove the transfer driven gear shaft locknut
and the conical spring washer.
COMPANION FLANGE HOLDER
07RAB - TII4010A or
07RAB - TII4010B
\
~
HOLDER HANDLE
07JAB - 001020A
23. Remove the transfer driven gear shaft and the com-
panion flange.
24. Install the new transfer spacer on the transfer dri-
ven gear shaft, then install them in the transfer
housing.
TRANSFER DRIVEN
GEAR SHAFT
\
TRANSFER SPACER
Install in this direction.
Replace.
" i
TRANSFER
HOUSING
25. Install the companion flange, O-ring, back-up ring,
conical spring washer and locknut on the transfer
driven gear shaft.
NOTE:
• Coat the threads of the locknut, and transfer
shaft with ATF before installing the locknut.
• Install the conical spring washer in the direction
shown.
COMPANION
FLANGE
BACK-UP RING
TRANSFER HOUSING
TRANSFER DRIVEN
GEAR SHAFT
O-RING
CONICAL SPRING
WASHER
LOCKNUT
Replace.
(cont'd)
14-245