Honda CR-V 1997 Service Manual page 683

Installation
1. Install a new O-ring on the transfer assembly.
2. Clean the areas where the transfer assembly con-
tacts the transmission with solvent or carburetor
cleaner, and dry with compressed air. Then apply
ATF
to
the contact areas.
3. Install the transfer assembly on the transmission.
NOTE: While installing the transfer assembly, do
not allow dust or other foreign particles to enter the
transmission,
4. Install the rear stiffener.
8x 1.26 mm
24 N·m (2.4 kgf·m,
t7 IbHII
REAR STIFFENER
DOWEL PIN
O·RING
Replace.
10 x 1.25 mm
... N·m 14.5 kgf·m.
331bHII
TRANSFER
ASSEMBlY
5. Install the propeller shaft to the transfer assembly
by aligning the reference marks.
6.
7.
PROPELLER
SHAFT
8.,,25
mm
32 N'm (3.3 kgf·m,
241bf·ftl
Replace .
REFERENCE MARKS
Install the shift cable with the control pin, then
secure it with the snap pin. Do not bend the shift
cable excessively.
Install the shift cable cover.
SHIFT CABLE
COVER
CONTROL PIN
~
o 0
' " 8 .1.25 mm
22 N'm (2.2 kgf·m,
161bHII
(conl'dl
14-167