Honda CR-V 1997 Service Manual page 547

II]
Position
Line pressure (1) flows to the manual valve and the modulator valve. Line pressure (1) changes to line pressure (4) and
1st-hold clutch pressure at the manual valve, and changes to modulator pressure at the modulator valve. Modulator pres-
sure
(6)
flows to the left ends of the '-2 shift valve and 3-4 shift valve because shift control solenoid valve A is turned OFF
by the PCM. The 1-2 shift valve and the 3-4 shift valve are moved to the right side. Line pressure (4) becomes 1st clutch
pressure (10) at the 1-2 shift valve. 1st clutch pressure (10) is applied to the 1st clutch, and the 1st clutch is engaged. lst-
hold clutch pressure (18) flows to the 1st-hold clutch via the 3-4 shift valve and the '-2 shift valve. Power is transmitted
only during deceleration through the 1st-hold clutch.
NOTE:
• When used, "left" or "right" indicates direction on the hydraulic circuit.
• The hydrauliC circuit shows the '97 - 98 models (7 positions); the '99 - 00 models (6 positions) is similar.
(cont'd)
14-31