Reassembly - Honda CR-V 1997 Service Manual

Transfer Assembly
Reassembly (cont'd)
7. Secure the transfer housing in a bench vise with
soft jaws, then install the special tool on the com-
panion flange . To prevent damage to the transfer
housing, always use soft jaws or equivalent materi-
als between the transfer housing and the vise.
COMPANION FLANGE
HOLDER
07RAB - 0020000
/
TORQUE
WRENCH
8. Tighten the locknut while measuring the starting
torque so the starting torque is within 0.98 - 1.39
N·m (10.0 -14.2 kgf.cm, 8.68 -12.3 Ibl·in).
NOTE:
• Coat the threads of Ihe locknut. and the shaft
with MTF before installing the locknut.
• Do not stake the locknut in this step.
STARTING TORQUE:
0.98 - 1.39 N'm
(10.0 - 14.2 kgf·em, 8.68 - 12.3 IbNn)
13-54
9. Install the transfer
shah
assembly in the transfer
housing, then install the tapered roller bearing,
transfer shaft collar, 25 mm thrust shim, transfer
drive gear, conical spring washer, and locknut on
the transfer shaft.
NOTE:
• Coat the threads of the locknut, and the shaft
with MTF belore installing the locknut.
• Do not stake the locknut in this step.
TAPERED
nu'"~n.
BEARING
THRUST SHIM.
25
mm
Selective part
Replace.
TRANSFER SHAFT
ASSEMBLY
TRANSFER
'TiIANISFI,R SHAFT
COLLAR
"T1RA~ISAER
DRIVE
GEAR
CONICAL SPRING
WASHER
Replace.