Honda CR-V 1997 Service Manual page 775

Transmission
Installation
1. Flush the ATF cooler as described on page 14·264
and 14·265.
2. Install the torque converter assembly on the main -
shaft with a new O-ring.
3. Install th e starter on the transmission housing. and
in stall the 14 mm dowel pins in the torque co nverter
housing.
STARTER
14 mm DOWEL PIN
TORQUE CONVERTER
44 N'm (4.5 kgf'm.
331bf·hl
14mm
DOWEL PIN
4. Place the tran smission on a jack, and raise
it
to
engine level.
5. Attach the transmiss ion to the engine, then install
the rear engine mounting bolts and the transmis-
sion housing mounting bolt (rear side).
TRANSMISSION HOUSING
MOUNTING BOLT (REAR SIDEI
12 x 1.25 mm
64 Nom (6.5 kgf .....
41Ibf·h)
REAR ENGINE MOUNTING BOLTS
Replace.
14x1.Smm
83 N·m
18.5
kgf·m. 61 IbI·hl
6. Install the transmiss ion housing mounting bolt
(front side).
TRANSMISSION HOUSING MOUNTING BOLT
IFRONT SIDE)
12 x 1.25 mm
64 N·m (6.5 kgf·m.
411bf·h)
~
7. Install the transmission mount bracket. Tighten the
bolt loosely. then tighten the nuts to the specified
torque. and tighten the bolt to the specified torque.
12
x
1.25
mm
-~~.~~~-"~
BRACKET
12 x '.25 mm
14
N .... (1.5 kgf·m.
54Ibf·h)
TRANSMISSION MOUNT
(cont' d)
14-259