Chrysler 2005 Crossfire SRT6 Service Manual page 2060

9 - 136 ENGINE - ELECTRICAL DIAGNOSTICS
(P0133) O2 SENSOR 1/1 SHORT DELAY TIME (CONTINUED)
5.
SENSOR GROUND CIRCUIT
With the ignition on.
Measure the voltage on the Sensor Ground circuit at the O2 Sensor
harness connector.
Is the voltage above 0.1 volt?
Yes >> Check the Sensor Ground circuit for damage, short to
ground, open, or short to voltage. If OK, replace and pro-
gram the Powertrain Control Module. (Refer to 8 - ELEC-
TRICAL/ELECTRONIC
POWERTRAIN CONTROL MODULE - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Replace the Oxygen Sensor. (Refer to 14 - FUEL SYS-
TEM/FUEL INJECTION/O2 SENSOR - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
6.
INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
CONTROL MODULES/
ZH