Show Ip Bgp Cluster-List - Dell S4810 Reference Manual

neighbor maximum-prefix

show ip bgp cluster-list

View BGP neighbors in a specific cluster.
S4810
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] cluster-list
[cluster-id]
Parameters
vrf vrf-name
ipv4 unicast
cluster-id
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The following describes the show ip bgp cluster-list command shown in
Information
the following example.
Field
Network
454
(OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view cluster information of BGP neighbors
corresponding to that VRF.
(OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
(OPTIONAL) Enter the cluster id in dotted decimal format.
The range is 1 — 4294967295.
EXEC
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the destination network prefix of each BGP route.
— controls the number of network prefixes received.
Border Gateway Protocol