Dell S4810 Reference Manual page 797

Defaults The interface is disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
The shutdown command marks a physical interface as unavailable for traffic. To
Information
discover if an interface is disabled, use the show ip interface brief
command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is
disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic
continues to flow. Entering the shutdown command on a port channel disables all
traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, enter no shutdown on the port channel interface and at
least one interface within that port channel.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
interface port-channel
Commands
interface vlan
show ip interface
to display a table of interfaces and their status.
Interfaces
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
— creates a port channel interface.
— creates a VLAN.
— displays the interface routing status. Add the keyword brief
797