Show Ip Bgp Dampened-Paths - Dell S4810 Reference Manual

•
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
Information
The higher the administrative distance assigned to a route means that your
confidence in that route is low. Routes assigned an administrative distance of 255
are not installed in the routing table. Routes from confederations are treated as
internal BGP routes.
Related
router bgp
Commands

show ip bgp dampened-paths

View BGP routes that are dampened (non-active).
S4810
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] dampened-paths
Parameters
vrf vrf-name
ipv4 unicast
Command
•
Modes
•
Border Gateway Protocol
local-distance = 200
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
CAUTION: Dell Networking recommends not changing the administrative
distance of internal routes. Changing the administrative distances may cause
routing table inconsistencies.
— enters ROUTER mode on the switch.
(OPTIONAL) Enter the keywords vrf and then the name of
the VRF to view routes that are affected by a specific
community list corresponding to that VRF.
(OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
EXEC
EXEC Privilege
489