Priority-Group - Dell S4810 Reference Manual

Defaults none
Command

PRIORITY-GROUP

Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage By default:
Information
•
•
Related
•
Commands
•
•
priority-group
To use with an ETS output policy, create an ETS priority group.
S4810
Syntax
priority-group group-name
To remove the priority group, use the no priority-group command.
Parameters
group-name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Data Center Bridging (DCB)
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
All 802.1p priorities are grouped in priority group 0.
100% of the port bandwidth is assigned to priority group 0. The complete
bandwidth is equally assigned to each priority class so that each class has 12 to
13%.
priority-group — creates an ETS priority group.
priority-group qos-policy
output policy.
set-pgid — configures the priority-group.
Enter the name of the ETS priority group. The maximum is 32
characters.
— associates an ETS priority group with an ETS
545