Dell S4810 Reference Manual page 912

cp
rp1
rp2
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 6.4.1.0
Usage The following describes the show tcp statistics cp command shown in the
Information following example.
Field
Rcvd:
0 checksum
error...
329 packets...
17 dup...
912
Enter the keyword cp to view only TCP information from the
Control Processor.
Enter the keyword rp1 to view only TCP statistics from
Route Processor 1.
Enter the keyword rp2 to view only TCP statistics from
Route Processor 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced
Description
Displays the number and types of TCP packets received by
the switch.
• Total = total packets received
• no port = number of packets received with no
designated port
Displays the number of packets received with the following:
• checksum errors
• bad offset to data
• too short
Displays the number of packets and bytes received in
sequence.
Displays the number of duplicate packets and bytes
received.
IPv4 Routing