Application (For Http And Icmp) - Dell S4810 Reference Manual

all
Defaults None.
Command EIS Mode (conf-mgmt-eis)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)

application (for HTTP and ICMP)

Configure the management egress interface selection for HTTP and ICMP.
NOTE: Only the options that have been newly introduced are described here. For a complete
description on all of the keywords and variables that are available with this command, refer the
respective Command Reference Guide of the applicable platform of the Release 9.2(0.0)
documentation set.
S4810
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all | application-type} command.
Parameters
application-
type
all
Defaults None.
Command EIS Mode (conf-mgmt-eis)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.3.
(0.0)
804
Configure all applications.
Introduced on the Z9000, S4810, and S4820T.
Enter any of the following keywords:
• For HTTP, enter the keyword http.
• For ICMP, enter the keyword icmp.
Configure all applications.
Added support for the HTTP and ICMP traffic on the Z9000,
S4810, and S4820T.
Interfaces