Dell S4810 Reference Manual page 596

level1
level2
verbose
testname
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
596
and perform essential path verifications. In addition, they
verify the identification registers of the components on the
board.
Enter the keyword Level1 to run Level 1 diagnostics. Level 1
diagnostics is a smaller set of diagnostic tests with support
for automatic partitioning. They perform status/self test for
all the components on the board and test their registers for
appropriate values. In addition, they perform extensive tests
on memory devices (for example, SDRAM, flash, NVRAM,
EEPROM, and CPLD) wherever possible. There are no tests
on 10G links. At this level, stack ports are shut down
automatically.
Enter the keyword level2 to run Level 2 diagnostics. Level 2
diagnostics are a full set of diagnostic tests with no support
for automatic partitioning. Level 2 diagnostics are used
primarily for on-board loopback tests and more extensive
component diagnostics. Various components on the board
are put into Loopback mode and test packets are transmitted
through those components. These diagnostics also perform
snake tests using VLAN configurations. To test 10G links,
physically remove the unit from the stack.
Enter the keyword verbose to run the diagnostic in Verbose
mode. Verbose mode gives more information in the output
than Standard mode.
Enter the keyword level2 to run a specific test case.
Enclose the test case name in double quotes (" "). For
example: diag stack-unit 1 level1 testname
"first".
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced the verbose option.
Debugging and Diagnostics