Arp Backoff-Time - Dell S4810 Reference Manual

Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Usage You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when
Information creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid.
You can use the vrf attribute of this command to create a static ARP entry on
either a default or a non-default VRF. You cannot use this parameter to create any
static ARPs corresponding to management VRFs. When a VRF is deleted using the
no ip vrf command, all the static ARP configurations that belong to that VRF
are removed automatically.
Related
clear arp-cache
Commands
show arp

arp backoff-time

Set the exponential timer for resending unresolved ARPs.
S4810
Syntax
arp backoff-time seconds
Parameters
seconds
Defaults 30
Command CONFIGURATION
Mode
840
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— clears dynamic ARP entries from the ARP table.
— displays the ARP table.
Enter the number of seconds an ARP entry is black-holed.
The range is from 1 to 3600. The default is 30.
IPv4 Routing