Show Ip Ospf Timers Rate-Limit - Dell S4810 Reference Manual

Dell(conf-if-te-0/6)#
Related clear ip ospf statistics
Commands

show ip ospf timers rate-limit

Show the LSA currently in the queue waiting for timers to expire.
S4810
Syntax
show ip ospf [process-id | vrf vrf-name] timers rate-limit
Parameters
process-id
vrf vrf-name
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Open Shortest Path First (OSPFv2 and OSPFv3)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unknown-Pkt 0 Bad-LsReq 0
RtidZero 0
Neighbor ID 4.4.4.4
Packet Statistics
Hello DDiscr LSReq LSUpd LSAck
RX 5 2 1 3 2
TX 6 5 1 3 3
Timers
Hello 0 Wait 0 Grace 0
Dead 39 Transmit 4
Queue Statistics
LSU-Q-Len 0 LSU-Q-Wmark 1
LSR-Q-Len 0 LSR-Q-Wmark 1
— clears the packet statistics in all interfaces and neighbors.
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Enter the keyword vrf followed by the name of the VRF to
view LSAs corresponding to a specific VRF that are currently
in queue waiting for timers to expire.
EXEC
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
1231