Clear Tcp Statistics - Dell S4810 Reference Manual

Version 8.3.7.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
Use the vrf vrf-name attribute of this command to clear routes corresponding
Information
to either a specific VRF or the default VRF.
You cannot use this attribute to clear routes corresponding to a management VRF.
Related
ip route
Commands
show ip route
show ip route summary

clear tcp statistics

Clear TCP counters.
S4810
Syntax
clear tcp statistics [all | cp | rp1 | rp2]
Parameters
all
cp
rp1
rp2
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
848
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— assigns an IP route to the switch.
— views the routing table.
— views a summary of the routing table.
Enter the keyword all to clear all TCP statistics maintained
on all switch processors.
(OPTIONAL) Enter the cp to clear only statistics from the
Control Processor.
(OPTIONAL) Enter the keyword rp1 to clear only the
statistics from Route Processor 1.
(OPTIONAL) Enter the keyword rp2 to clear only the
statistics from Route Processor 2.
IPv4 Routing