Show Cam-Usage - Dell S4810 Reference Manual

Command
Version 9.3(0.0)
History
Usage The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP that
Information modifies the VLAN settings before packets are forwarded. To support the ACL CAM
optimization functionality, the CAM carving feature is enhanced. A total of four
VACP groups are present, of which two are for fixed groups and the other two are
for dynamic groups. Out of the total of two dynamic groups, you can allocate zero,
one, or two flow processor (FP) blocks to iSCSI Counters, OpenFlow and ACL
Optimization. You can configure only two of these features at a point in time.

show cam-usage

View the amount of CAM space available, used, and remaining in each partition (including IPv4Flow and
Layer 2 ACL sub-partitions).
Syntax
show cam-usage [acl | router | switch]
Parameters
acl
router
switch
Command EXEC
Modes
EXEC Privilege
Command
Version 9.3.
History
(0.0)
Usage The following regions must be provided in the show cam-usage output:
Information
•
•
•
The following table describes the output fields of this show command:
354
Introduced on the S4810 and Z9000 platforms.
(OPTIONAL) Enter the keyword acl to display Layer 2 and
Layer 3 ACL CAM usage.
(OPTIONAL) Enter the keyword router to display Layer 3
CAM usage.
(OPTIONAL) Enter the keyword switch to display Layer 2
CAM usage.
Introduced on the S4810, S4820T, Z9000 and MXL
platforms.
L3AclCam
L2AclCam
V6AclCam
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)