Advertise Med Location-Identification - Dell S4810 Reference Manual

Parameters
vlan-id
layer2_priority
DSCP_value
priority-tagged
number
Defaults unconfigured.
Command CONFIGURATION (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Related
debug lldp interface
Commands
show lldp neighbors

advertise med location-identification

To advertise a location identifier, configure the system.
S4810
Syntax
advertise med location-identification {coordinate-based value |
civic-based value | ecs-elin value}
To return to the default, use the no advertise med location-
identification {coordinate-based value | civic-based value |
ecs-elin value} command.
Parameters
coordinate-
based value
1094
Enter the VLAN ID. The range is from 1 to 4094.
Enter the Layer 2 priority. The range is from 0 to 7.
Enter the DSCP value. The range is from 0 to 63.
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series and E-Series.
— debugs LLDP.
— displays the LLDP neighbors.
Enter the keywords coordinate-based then the
coordinated based location in hexadecimal value of 16 bytes.
Link Layer Discovery Protocol (LLDP)