Pfc Commands; Clear Pfc Counters - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
By default, iSCSI is enabled on the unit and flow control is enabled on all of the
Information
interfaces or if link-level flow control is enabled on one or more interfaces. To
enable DCB, do one of the following:
•
•
Related dcb-policy input
Commands ingress interface.

PFC Commands

The following PFC commands are supported on the S4810 platform.

clear pfc counters

Clear the PFC TLV counters and PFC statistics on an interface or stack unit.
S4810
Syntax
clear pfc counters [port-type slot/port | stack-unit {unit
number | all } all stack-ports all}]
Parameters
port-type
stack-unit unit
number
all stack-ports
all
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
520
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Apply the dcb-input policy command with the no pfc-mode command on
to all the interfaces.
Disable flow-control on all of the interfaces.
— applies the input policy with the PFC configuration to an
Enter the keywords port-type then the slot/port
information.
Enter the keywords stack-unit then the stack-unit number
to be cleared.
Enter the keywords all stack-ports all to clear the
counters on all interfaces.
Data Center Bridging (DCB)