Interface Port-Channel - Dell S4810 Reference Manual

Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Related
port-channel failover-group
Commands
mode to configure a LAG failover group.
show interfaces port-channel
groups.

interface port-channel

Create a Port Channel interface, which is a link aggregation group (LAG) containing eight physical
interfaces on the S-Series.
S4810
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-
number command.
Parameters
channel-
number
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Interfaces
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series, E-Series, and S-Series.
— accesses PORT-CHANNEL FAILOVER-GROUP
— displays information on configured Port Channel
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on S4810.
Introduced on Z9000.
Introduced on E-Series ExaScale.
Introduced on S-Series.
Introduced on C-Series.
811