Dell S4810 Reference Manual page 1154

CPU
interface
interface
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.1
Example
Dell#show ipv6 neighbors
IPv6 Address Expires(min) HardwareAddress State Interface/VLAN/
CPU
---------------------------------------------------------
fe80::201:e8ff:fe17:5bc6
fe80::201:eff:fe17:5bc7
fe80::201:e8ff:fe17:5bc8
fe80::201:e8ff:fe17:5caf
fe80::201:e8ff:fe17:5cb0
fe80::201:e8ff:fe17:5cb1
fe80::201:e8ff:fe17:5cae
fe80::201:e8ff:fe17:5cae
1154
Enter the keyword cpu then either rp1 or rp2 (Route
Processor 1 or 2), optionally then an IPv6 address to display
the IPv6 neighbor entries stored on the designated RP.
Enter the keyword interface then the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
EXEC
EXEC Privilege
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
1439
1439
1439
0.3
1439
1439
1439
00:01:e8:17:5b:c6 STALE
00:01:e8:17:5b:c7 STALE
00:01:e8:17:5b:c8 STALE
00:01:e8:17:5c:af REACH
00:01:e8:17:5c:b0 STALE
00:01:e8:17:5c:b1 STALE
00:01:e8:17:5c:ae STALE
Gi 1/9 -
Gi 1/10 -
Gi 1/11 -
Po 1 -
Po 32 -
Po 255 -
Gi 1/3 Vl 100 CP
Neighbor Discovery Protocol (NDP)
CP
CP
CP
CP
CP
CP