Debug Ip Bgp Events - Dell S4810 Reference Manual

To disable debugging, use the no debug ip bgp ipv4 multicast dampening
command.
Parameters
dampening
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0

debug ip bgp events

Display information on local BGP state changes and other BGP events.
S4810
Syntax
debug ip bgp [ip-address | peer-group peer-group-name] events
[in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] events command.
Parameters
ip-address
peer-group
peer-group-
name
in
out
Border Gateway Protocol
Enter the keyword dampening to debug route flap
dampening information.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced IPv6 MGBP support for the E-Series.
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
(OPTIONAL) Enter the keyword in to view only events on
inbound BGP messages.
(OPTIONAL) Enter the keyword out to view only events on
outbound BGP messages.
409