Timers Throttle Lsa All - Dell S4810 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage Setting the delay and holdtime parameters to a low number enables the switch to
Information an alternate path quickly but requires more CPU usage.

timers throttle lsa all

Configure LSA transmit intervals.
S4810
Syntax
timers throttle lsa all {start-interval | hold-interval | max-
interval}
To return to the default, use the no timers throttle lsa command.
Parameters
start-interval
hold-interval
max-interval
Defaults
•
•
•
Command ROUTER OSPF
Modes
Open Shortest Path First (OSPFv2 and OSPFv3)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Set the minimum interval between initial sending and
resending the same LSA. The range is from 0 to 600,000
milliseconds.
Set the next interval to send the same LSA. This interval is the
time between sending the same LSA after the start-interval
has been attempted. The range is from 1 to 600,000
milliseconds.
Set the maximum amount of time the system waits before
sending the LSA. The range is from 1 to 600,000
milliseconds.
start-interval: 0 msec
hold-interval: 5000 msec
max-interval: 5000 msec
1235