Log-Adjacency-Changes - Dell S4810 Reference Manual

log-adjacency-changes

To send a Syslog message about changes in the OSPF adjacency state, set Dell Networking OS.
S4810
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes
command.
Defaults Disabled.
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
maximum-paths
Enable the software to forward packets over multiple paths.
S4810
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths
command.
Parameters
number
1188
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify the number of paths. The range for OSPFv2 is from 1
to 64. The default for OSPFv2 is 4 paths. The range for
OSPFv3 is from 1 to 64. The default for OSPFv3 is 8 paths.
Open Shortest Path First (OSPFv2 and OSPFv3)