Show Config - Dell S4810 Reference Manual

Version 9.0.2.0
Version 9.1(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.9.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage You must have an IP address assigned to an interface to enter ROUTER OSPF mode
Information and configure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF
Process ID again in the system.
Example
Dell(conf)#router ospf 2
Dell(conf-router_ospf)#

show config

Display the non-default values in the current OSPF configuration.
S4810
Syntax
show config
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
1198
Introduced on the S6000.
Added support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRF.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)