Version 6.2.1.1
Related
show lacp
Commands
debug lacp
Debug LACP (configuration, events, and so on).
S4810
Syntax
debug lacp [config | events | pdu [interface-type [in | out]]]
To disable LACP debugging, use the no [config | events | pdu
[interface-type [in | out]]] command.
Parameters
config
events
pdu
interface-type
in | out
Defaults
none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1030
Introduced on the E-Series.
— displays the LACP configuration.
(OPTIONAL) Enter the keyword config to debug the LACP
configuration.
(OPTIONAL) Enter the keyword events to debug the LACP
event information.
(OPTIONAL) Enter the keyword pdu to debug the LACP
Protocol Data Unit information.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
•
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
•
For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Optionally, enter an in or out parameter:
•
Receive enter in
•
Transmit enter out
EXEC
EXEC Privilege
Link Aggregation Control Protocol (LACP)