Dell S4810 Reference Manual page 482

Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The following describes the show ip bgp regexp command shown in the
Information
following example.
Field
Network
Next Hop
Metric
LocPrf
Weight
Path
Example
Dell#show ip bgp regexp ^200
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed
Origin codes: i - IGP, e - EGP, ? - incomplete
Weight Path
*>
172.16.0.2
482
EXEC
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the destination network prefix of each BGP route.
Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then non-BGP routes exist in the
router's routing table.
Displays the BGP router's metric, if assigned.
Displays the BGP LOCAL_PREF attribute for the route.
Displays the route's weight
Lists all the AS paths the route passed through to reach the
destination network.
n - network,
Network
55.0.0.0/24
D - denied, S - stale
Next Hop Metric LocPrf
0 200 i
Border Gateway Protocol