Ipv6 Unknown-Unicast; Show Cpu-Queue Rate Cp - Dell S4810 Reference Manual

Usage Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route
Information forwarding table if it was deleted using the no ip unknown-unicast command
previously. This will be the default configuration after reload.

ipv6 unknown-unicast

Disable soft forwarding of unknown IPv6 destination packets.
S4810 MXL Switch
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command CONFIGURATION
Modes
Command
Version 9.4(0.0)
History
Usage All the default catch-all entries in the longest prefix match (LPM) table collect and
Information transmit all unresolved IPv6 packets to the CPU, even if they are destined for
unknown destinations.

show cpu-queue rate cp

Display the rates for each CPU queue.
S4810
Syntax
show cpu-queue rate cp
Defaults Not configured.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
514
Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Introduced on the S6000.
Introduced on the S4820T.
Control Plane Policing (CoPP)