Version
8.3.19.0
Version 8.3.11.0
Version 8.3.7.0
Version 7.8.1.0
Related
show hardware stack-unit
Commands
and output statistics of the designated component of the designated stack
member.
hardware watchdog
To trigger a reboot and restart the system, set the watchdog timer.
S4810
Syntax
hardware watchdog stack-unit {<0-5> | all}
Defaults
Enabled.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.0
Version 8.3.7.0
Version 7.8.1.0
Usage
This command enables a hardware watchdog mechanism that automatically
Information
reboots an Dell Networking OS switch/ router with a single unresponsive unit. This
behavior is a last-resort mechanism intended to prevent a manual power cycle.
show hardware layer2
Display Layer 2 ACL or eg data for the selected stack member and stack member port-pipe.
S4810
Syntax
show hardware layer2 {eg-acl | in-acl} stack-unit id port-set
0–0
602
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
— displays the data plane or management plane input
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Debugging and Diagnostics