Ip Dhcp Source-Address-Validation - Dell S4810 Reference Manual

Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 7.8.1.0

ip dhcp source-address-validation

Enable the IP Source Guard.
S4810
Syntax
[no] ip dhcp source-address-validation [ipmac]
Parameters
ipmac
Defaults Disabled
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 7.8.1.0
Usage
Allocate at least one FP block to ipmacacl before you can enable IP+MAC Source
Information
Address Validation.
1.
2.
3.
Dynamic Host Configuration Protocol (DHCP)
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
Enable IP+MAC Source Address Validation.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Added the keyword ipmac.
Introduced on the C-Series and S-Series.
Use the cam-acl l2acl command from CONFIGURATION mode.
Save the running-config to the startup-config.
Reload the system.
633