Show Ip Fib Stack-Unit - Dell S4810 Reference Manual

show ip fib stack-unit

View all FIB entries.
S4810
Syntax
show ip fib stack-unit id [ip-address [mask] [longer-prefixes]
| summary]
Parameters
id
ip-address
mask
longer-prefixes
summary
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Usage The following describes the show ip fib stack-unit command shown in the
Information
following example.
Field
Destination
Gateway
894
Enter the S-Series stack unit ID. The unit ID range is from 0
to 11 for the S4810.
(OPTIONAL) Enter the IP address of the network destination
to view only information on that destination. Enter the IP
address in dotted decimal format (A.B.C.D). Enter the mask in
slash prefix format (/X).
(OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
(OPTIONAL) Enter the keyword summary to view the total
number of prefixes in the FIB.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for up to seven stack members.
Introduced on the S-Series.
Description
Lists the destination IP address.
Displays either the word "direct" and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
IPv4 Routing