Dell S4810 Reference Manual page 1268

Parameters
interface
Defaults none
Command
EXEC
Modes
Command
Version 9.2.
History
(0.0)
Version 9.1.
(0.0)
Version
8.3.19.0
Version 7.8.1.0
Version 7.4.1.0
Usage
If you enable BFD at the global level, show ipv6 ospf interface shows the BFD
Information
provisioning.
If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD
interval timers.
Example
Dell#show ipv6 ospf interface gigabitethernet 1/0
GigabitEthernet 1/0 is up, line protocol is up
67420217
Retransmit 5
1268
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet and the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet and the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE and the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel and a number. The range is from 1 to 128.
• For a Tunnel interface, enter the keywords tunnel and a
number. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan and a number from
1 to 4094.
Added support for showing BFD status on the S4820T,
S4810, and Z9000.
Added support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Added support for the C-Series.
Introduced on the E-Series.
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Interface is using OSPF global mode BFD configuration.
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1,
Open Shortest Path First (OSPFv2 and OSPFv3)