Dell S4810 Reference Manual page 1223

•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The following describes the show ip ospf process-id interface command
Information
shown in the following example.
Item
GigabitEthernet...
Internet Address...
Process ID...
Transmit Delay...
Designated
Router...
Backup
Designated...
Timer intervals...
Hello due...
Open Shortest Path First (OSPFv2 and OSPFv3)
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
This line identifies the interface type slot/port and the status
of the OSPF protocol on that interface.
This line displays the IP address, network mask and area
assigned to this interface.
This line displays the OSPF Process ID, Router ID, Network
type and cost metric for this interface.
This line displays the interface's settings for Transmit Delay,
State, and Priority. In the State setting, BDR is Backup
Designated Router.
This line displays the ID of the Designated Router and its
interface address.
This line displays the ID of the Backup Designated Router
and its interface address.
This line displays the interface's timer settings for Hello
interval, Dead interval, Transmit Delay (Wait), and Retransmit
Interval.
This line displays the amount time until the next Hello
packet is sent out this interface.
1223