Dell S4810 Reference Manual page 480

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.8.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The following describes the show ip bgp peer-group command shown in the
Information
following example.
Line beginning
with:
Peer-group
Administratively
shut
BGP version
Minimum time
For address family
BGP neighbor
Number of peers
Peer-group
members:
Example
Dell#show ip bgp peer-group
Peer-group port0, remote AS 200
BGP version 4
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP neighbor is port0, peer-group external
Update packing has 4_OCTET_AS support enabled
Number of peers in this group 1
Maximum limit on the accepted connections 256
480
Added support for VRF.
Introduced on the S4820T.
Introduced on the Z9000.
Added the add-path option to the S4810. Output on the
S4810 shows the ADDPATH parameters.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the peer group's name.
Displays the peer group's status if the peer group is not
enabled. If you enable the peer group, this line is not
displayed.
Displays the BGP version supported.
Displays the time interval between BGP advertisements.
Displays IPv4 Unicast as the address family.
Displays the name of the BGP neighbor.
Displays the number of peers currently configured for this
peer group.
Lists the IP addresses of the peers in the peer group. If the
address is outbound optimized, an * is displayed next to the
IP address.
Border Gateway Protocol